This content has been prepared in compliance with relevant laws including the Medical Service Act.

When considering lifting procedures, many ask "Which is better between Sofwave and Inmode?" In fact, the two procedures are not competitors but rather operate on different skin layers. Sofwave restores elasticity to the mid-dermis layer (1.5mm), while Inmode delivers energy to the fat layer and SMAS layer to refine contours. Therefore, it is crucial to consult at a clinic that has both devices and where the director can directly evaluate skin condition.


Why You Need a Clinic in Gaepodong That Does Both Sofwave and Inmode

Sofwave and Inmode are procedures with completely different energy methods and target depths. Sofwave concentrates energy precisely at 1.5mm depth in the dermis using SUPERB™ parallel ultrasound beams, while Inmode reaches the fat and SMAS layers through radiofrequency and high-voltage electrical stimulation. In other words, because the skin structures addressed by the two procedures are fundamentally different from the start, there are areas that cannot be covered by a single device.

Related professional media materials mention that when combining the two procedures, simultaneous approach to different depths is possible. However, for this design to be executed properly, a clinic must possess both devices and the director must directly evaluate skin condition and determine treatment direction.

When searching for lifting dermatology clinics in Gaepodong and Daechidong, we recommend prioritizing clinics that have both Sofwave and Inmode and where the director personally performs procedures with genuine equipment, rather than places offering only one of the two procedures. If you're considering Sofwave consultation in Dogokdong, it's good to check equipment ownership along with treatment design methodology.

ClassificationSofwaveInmode
Energy MethodSUPERB™ Parallel UltrasoundRadiofrequency + High-voltage Electrical Stimulation
Primary Target LayerDermis 1.5mm (Elasticity Layer)Fat Layer · SMAS Layer
Primary PurposeFine wrinkle improvement, skin elasticity recoveryFat reduction, contour definition
Combined EffectSimultaneous approach to different depths possible

Sofwave vs Inmode — Complete Comparison of Principle, Target Layer, and Effect

Understanding the differences between the two procedures makes it much clearer which combination is right for you.

Sofwave creates a thermal coagulation point of 60-70℃ at 1.5mm depth in the dermis using seven parallel ultrasound beams (SUPERB™ technology). Since the SofCool™ cooling system simultaneously cools the skin surface, selective stimulation of only the dermal layer is possible without epidermal damage. Related clinical data indicates that changes begin to be felt gradually from 1-4 weeks after treatment, become more pronounced at 8-12 weeks, and reach their peak around 3-6 months. In particular, it is known as a procedure with relatively low risk of hollow cheeks side effects, making it applicable even to those with thin faces or thin skin.

Inmode is divided into FX mode and FORMA mode. FX applies vacuum suction followed by simultaneous radiofrequency and approximately 2,000V high-voltage electrical stimulation to directly target the fat layer, while FORMA uniformly heats the skin surface to 43℃ to induce collagen remodeling. Doctor Now Health Magazine indicates that when combining FX and FORMA, treatment plans often aim simultaneously at fat reduction and skin elasticity improvement.

ClassificationSofwaveInmode FXInmode FORMA
EnergyParallel Ultrasound (SUPERB™)Radiofrequency + High-voltage Electrical StimulationRadiofrequency (Surface Heating)
Target DepthDermis 1.5mmFat Layer · SMAS LayerSkin Surface
Primary EffectFine wrinkle improvement, elasticity recoveryFat apoptosis, contour reductionCollagen remodeling, elasticity
Cooling SystemSofCool™ Simultaneous CoolingNegative Pressure Suction Method—
Suitable ConcernsFine wrinkles, mild to moderate elasticity lossDouble chin, cheek fatGeneral skin elasticity
Effect Manifestation4-12 weeks, peak at 3-6 monthsFelt from 2-4 weeks afterGradual changes

If you have thin skin or fine wrinkles as your main concern without much cheek fat, Sofwave becomes a priority consideration. If palpable double chin or cheek fat is bothersome, Inmode FX can be a more direct approach.


Why Sofwave and Inmode Are Chosen at Shinyu clinic

If you want both Sofwave and Inmode procedures, you must first verify whether a clinic actually possesses both devices. Shinyu clinic, located near Yangjaeyeok Station, possesses Sofwave, Inmode FX, and Inmode FORMA, and operates a structure where the director personally executes everything from consultation to procedure completion on a 1:1 basis.

In particular, it operates on principles of genuine and proper-quantity standards, directly opening and confirming genuine devices and tips in front of patients, and provides transparent procedure pricing to clearly inform costs. For patients choosing sleep anesthesia, an anesthesiology specialist is stationed in the procedure room to safely monitor the system. As a Gangnam-area clinic accessible from Gaepodong, Daechidong, and Dogokdong, you can receive customized design for both procedures under evaluation by the same director.

If you want lifting design tailored just for you, 1:1 personalized care at Shinyu clinic, where the director carefully performs procedures, can be an option.

Sofwave 60 shots 540,000 won / 100 shots 850,000 won / 200 shots 1,600,000 won (including VAT)
Inmode procedures are designed to match your skin condition after in-office consultation.


Cheek Fat, Fine Wrinkles, Thin Face — Which Procedure Suits My Skin Better?

Before deciding on a procedure, check the self-assessment checklist below first. The appropriate procedure varies depending on skin thickness, fat distribution, and degree of sagging.

✅ Cases Where Sofwave Is More Suitable

• You have little cheek fat and thin skin
• Fine wrinkles and mild to moderate skin elasticity loss are your primary concerns
• You were hesitant about ultrasound lifting due to concerns about hollow cheek side effects
• You want quick return to daily activities after treatment

Related clinical data indicates that Sofwave can be applied without hollow cheek concerns even when facial fat is absent or skin is thin, and is known to work well for fine wrinkles and mild to moderate elasticity loss.

✅ Cases Where Inmode FX Is More Suitable

• You are concerned about palpable cheek fat and double chin fat
• Your goal is facial contour reduction and fat decrease rather than simple elasticity
• You want direct approach to the fat layer and SMAS layer

Clinical cases indicate that when facial fat is minimal, Inmode FX application range and intensity settings must be adjusted carefully. Since intensity and shot number settings must vary based on individual skin condition, it is important to have medical staff make a direct diagnosis and determine direction.

✅ Cases Where Combined Treatment May Be Considered

• You have two concerns simultaneously—fine wrinkles and cheek fat
• You want to design both skin elasticity recovery (Sofwave) and contour definition (Inmode FX) at once
• You want simultaneous approach to two depths while minimizing downtime

Clinical cases indicate that when combining two procedures, adjustment of energy intensity and treatment sequence is very important, and individual differences in effect and maintenance duration can be large depending on personal skin condition.

If you are searching for Daechidong lifting dermatology or Dogokdong Sofwave clinics, be sure to check both device ownership and whether the director provides direct diagnosis. We also recommend comparing Yangjaeyeok Inmode dermatology while reviewing accessibility and treatment design methodology.


Lifting Is Determined by 'How to Design' Rather Than 'What to Choose'

Under Shinyu clinic's transparent procedure pricing and genuine·proper-quantity principles, the director personally designs lifting combinations perfectly tailored to your skin.

Sofwave and Inmode each have clear roles. Since Sofwave handles dermal elasticity layer and Inmode handles fat and SMAS layer, when combined they can simultaneously approach different depths. However, as confirmed in clinical cases, both procedures require energy intensity, shot number, and area settings to be finely adjusted according to individual skin condition, and use of genuine equipment and whether the director personally performs the procedure directly affect final results.

Lifting procedures are determined more by how the equipment is designed and by whom than by which device is chosen. If you are looking for clinics in Gangnam area starting from Gaepodong, first establish whether both procedures can be personally designed 1:1 by the director as your primary criterion.


Sofwave and Inmode, What Happens If You Actually Get Both?

Q1. Can I have Sofwave and Inmode together on the same day?

Sofwave (dermis 1.5mm) and Inmode (fat layer and SMAS layer) have different energy target depths, so combined treatment can be considered. However, if two procedures are performed on the same day, energy intensity and sequence of each procedure must be adjusted to individual skin condition, so it is important to make the decision under direct medical staff diagnosis and judgment.

Q2. I want to reduce fine wrinkles but I also have cheek fat — Which procedure should I get first?

Fine wrinkles (elasticity layer) and cheek fat (fat layer) are concerns at different depths, so combining Sofwave and Inmode FX can be considered. Which procedure to receive first depends on skin thickness, fat distribution, and degree of sagging, so the treatment sequence should be determined after the director's direct skin evaluation.

Q3. When do I start feeling the effect, and how long does it last?

Sofwave is known to gradually show changes starting 4-12 weeks after treatment and reach peak effect around 3-6 months. Inmode often shows effects felt from 2-4 weeks after treatment. However, both procedures show large individual variations in effect manifestation timing and maintenance duration depending on personal skin condition, so use this as a reference only.


Non-covered medical care costs are posted and informed within the clinic in accordance with Article 45 of the Medical Service Act.